If you did not have the DeskScan II Installation Program make changes
to CONFIG.SYS, AUTOEXEC.BAT, and WIN.INI, here are the changes that
you must make yourself.  Make these changes by using a text editor.

CONFIG.SYS:
-----------
Add a line at the bottom of the CONFIG.SYS file to load the driver
for your scanner.  For example, if you have a ScanJet IIc scanner or
a Scanjet IIp scanner, the line you add would probably look like this:

DEVICE=C:\DESKSCAN\SJII.SYS

If you have a ScanJet Plus scanner, specify the ScanJet Plus driver:

DEVICE=C:\DESKSCAN\SJDRIVER.SYS

Choose only one of these statements to add to the CONFIG.SYS file.
You cannot have both scanner drivers loaded at the same time.


AUTOEXEC.BAT
------------
Add the DeskScan subdirectory to the end of your PATH statement.  
For example, if your original PATH statement is:

PATH=C:\DOS;C:\WINDOWS

Change it to:

PATH=C:\DOS;C:\WINDOWS;C:\DESKSCAN


WIN.INI
-------
The following section is needed for PhotoFinish.  Add
these lines to the end of your WIN.INI file.

[PhotoFinish]
Path=C:\DESKSCAN (or your path)
Version=1.0

[ZSoftDll]
PCX 16 Color/Gray=pcx16.dll, *.pcx

[ZSoftVM]
enable=0
minkb=128
maxkb=1024
PbTemp=c:\
